FREQUENTLY ASKED QUESTIONS

• Cycle using the "Flame" button between settings P1, P2, P3, and P4
• P1 is the fastest setting
• P4 is the slowest setting

• Press and hold the "Wrench" button for two (2) seconds
• Press the "thumbs up" to get to cycle to each of the Pellet Drop Rate Settings
• Adjust the "S" for Venting Fan and "F" for Blower Fan settings using the arrow keys
• Use the "Clock" button to switch between "S" and "F"
• The lower the setting the slower the fan
• Only change settings by a few numbers at a time

• Press and hold the "Wrench" button for two (2) seconds
• Use the "Thumbs Up" button to cycle to the "Modify Clock" Setting
• Use the "Clock" button to switch between Hours and Minutes
• Use the "Arrow Up" and "Arrow Down" buttons to change the current selection
• Use the "Thumbs Up" button to confirm the time set

• Press and hold the "Wrench" button for two (2) seconds
• Cycle through the settings using the "Thumbs Up" button until you find the different days of the week
• Use the "clock" button to change between options (The screen with 24 little boxes)
• Use the "Arrow" buttons to adjust if on or off for each day
• A Tall Box is for "On" and the Short Box is for "Off"
• Each box is for an hour of the day, the first box is 00:00 (Midnight) and the last box is for 23:00 (11PM)

Using the "Wrench" Button again will take you out of the settings menu

• Press and hold the up arrow until it asks for a 4-digit password
• Use the arrow keys and clock button to input 1109 as the password
• Thumbs-up to confirm, and then press the thumbs-up 17 times to get to the Wi-Fi enabled option. (Open or Closed)
• Press clock button to switch over to the "closed" setting
• Thumbs up one more time and then the wrench button will take you out of the password protected settings menu

• Press and hold the up arrow until it asks for a 4-digit password
• Use the arrow keys and clock button to input 1109 as the password
• Press Thumbs-up to confirm, and then press the thumbs-up 18 more times to get to the Temperature Type
• It will show a F for Fahrenheit and a C for Celsius
• Press clock button to switch over to the desired readout setting
• Press the wrench button to take you out of the password protected settings menu

• Press and hold the "Wrench" Button until the heater beeps
• Press (Do Not Hold) the "Thumbs Up" button seven (7) times to cycle to the screen that reads "ECO Mode" on the top line
• Press "Clock" Button to switch between the selected Eco Modes
• Press "Wrench" Button to leave the settings menu

• Unit will run until desired temperature is reached
• Once temperature is reached, unit will go through shut down
• Stove will relight when thermostat reads the temperature is out of range
• 2-3 degrees away from your desired setting
• The stove will go into stabilization and run until it reaches temperature
• Cycle will repeat

• Stove will run even if desired temperature is reached
• When temperature is reached the unit will slow the pellet drop rate (P4)
• In some cases, the temperature in the room will continue to raise
• Once the thermostat reads the temperature out of range it will change to a faster setting (P1) to raise the temperature